-If you're looking for the STRONGEST anchor on the market, look no further! -Made in the USA -This product converts your factory Lock N Ride hole into a threaded bolt hole making it easy to mount anything to the bed of your Ranger securely! -This sale is for 1 anchor & the included hardware (package shown in pictures). -Precision machined from aluminum, this anchor installs / removes in minutes. This HD anchor may require you to temporarily remove some side bed plastic to install depending on what Lock N Ride hole you are putting it in. Simply drop these in, tighten from underneath, and it's ready to anchor your accessories! Once this anchor is installed, it will lock n place from below the Lock N Ride hole meaning it can't pull out like the expansion type anchors that rely on friction are well known to do. -Another great use for these, is just using them as a tie down point. Simply replace the included bolt with an eye-bolt (sold separately) and these can be used to strap anything down in the bed of your Ranger. Expansion anchors will pull out when ratcheting down a load tightly while Accessory Anchors stay locked in place. -Ranger beds have varied over the years, so be sure to look at the hole requirements before purchasing to make sure it will fit in your ride. -The hole must go all the way through, meaning it can't have a bottom and can be no deeper than 5.5" from the top of the bed to the bottom of the hole. -These will fit newer machines, 2018-2024 for sure. Haven't had any older ones available to check yet.